LINK Indoor

LINK Indoor units provide a conveniently centralized package for compressors, electrical, and controls, allowing for maximized merchandising space. With its lightweight, and simplified design, this unit provides ample refrigeration capacity for most applications. Paired with selections from our complete line of companion products, LINK Indoor units will allow you to create the ultimate system perfect for your refrigeration needs.

Indoor parallel compressor package available in vertical and horizontal configurations to fit space constraints. Small footprint, light weight and simplified design creates a viable option from cost and serviceability standpoint. Accommodates up to 8 scroll compressors, each up to 8.5 HP, providing ample refrigeration capacity for most applications.
  • Galvanized sheet metal cabinet
  • Accommodates up to (8) 8.5HP scroll compressors
  • Motor starters provide protection against overload and phase failures
  • High efficiency IEC Contactors for compressor control
  • Master phase monitor to shut down compressors in case of a phase loss
  • Crankcase heater per compressor
  • Catch-All suction filter per suction group (shipped loose)
  • Discharge thermostats per compressor
  • Low- and high-pressure safety controls per compressor
  • Discharge vibrasorbers per compressor for ease of compressor removal
  • Electronic oil management system per compressor
  • Coalescent oil separator for high-efficiency oil separation
  • Discharge check valve to prevent back flow of gas from the condenser
  • All suction pipes insulated at factory
  • Charged with helium and leak checked
  • Vacuumed below 500 microns and holding for 24hrs
  • Shipped with holding pressure of nitrogen
  • Vibration pads to prevent transfer of vibration (shipped loose)
  • All components UL certified
  • Powder painted cabinet
  • Sound insulated cabinet
  • Ventilation fan for cooling cabinet and electrical panel
  • Mechanical subcooling
  • Heat reclaim
  • Mounted leak detector for all refrigerant types
  • Cross over CPR for load capacity control
  • CPC, Micro Thermo, Danfoss and Other Controllers
  • Control boards for evaporator monitoring and control
  • Run proofs for compressor and evaporator fans
  • Mounted disconnect switch where possible
  • Additional electrical panel shipped loose
  • Mounted 3-way valve and other piping components
  • Branch circuits
  • Receiver skid option